Maintenance Manual

910-0001-00-INS -R05 FLIR Proprietary Information Page 12 of 53
Information contained in this document pertains to a Canadian origin product that is controlled as "dual use" by the Canadian
government. However, when in the United States or possessed by a US person, it may be considered a defense article from the US Government's
perspective. US government authorization may be required for re-transfer to a foreign person. If you have any questions, please contact FLIR's
Global Trade Compliance group at [e-mail] .
1.2 SAFETY ISSUES
This equipment generates Radio Frequency energy and is intended for outdoor installation only. Based
on limits specified by the Federal Communication Commission (FCC) on Radio Frequency (RF) Emissions,
the safety distances listed in the table below must be respected to ensure personnel safety.
Caution!
The installation must provide a separation distance from all persons and must not be co-located or
operating in conjunction with any other antennas or transmitters. This safety distance complies with the
FCC Limits for Maximum Permissible Exposure (MPE) for general population / uncontrolled exposure.
Safety Distances
Nominal
Output Power
Frequency Band
FCC MPE distance (cm)
Controlled Exposure General Population
R1,R2,R3 0.8 Watt Ka 22 22
R3D (FastScan) 0.8 Watt Ka 22 22
R3D (Doppler) 0.8 Watt Ka 22 22
R5,R5D 0.56 Watt Ka 13 28
R5D (Doppler) 0.56 Watt Ka 25 55
Note: theses distances are for guidance only
1.3 UNPACKING THE R1, R2, R3, R3D, R5 and R5D RADAR ASSEMBLY
Following verification of the shipping documents, move case to a clean area. Open case and follow
these steps:
Step 1 Inspect packing for any damage. If damage is noted, take photos and contact shipper.
Step 2 Remove packing material and retain for future use.
Step 3 Remove unit carefully.
Step 4 Place it on a flat clean surface, being careful not to damage the connector on the underside
of the unit.
Step 5 Compare the part and serial numbers appearing on the shipping invoice with the part and
serial numbers appearing on each unit.
Step 6 If they do not match, contact your distributor/retailer with details.
Step 7 Make a list of items received versus items ordered and note each item’s condition upon
receipt.
Step 8 If they do not match, contact your distributor/retailer with details.
Step 9 Make a visual inspection of each unit to ensure it was not damaged during shipment.
Step 10 Keep this report. If there is damage, it is best to make digital photographs to aid with the
claims process with the carrier.
Note
The R5 or R5D Radar is shipped with foam material to secure the antenna during transportation.
Follow the special unpacking procedures provided inside the shipping case. If you can’t find the
unpacking procedures, contact customer support to request a copy.