User's Guide
Table Of Contents
- Table of Contents
- Radar Overview
- Installation
- 2.1 Configuring the Radar for Networking
- 2.2 Radar Placement and Orientation
- 2.3 Site Preparation
- 2.4 Installing the Wall Mount Bracket
- 2.5 Connecting the Radar and Installing the Back Box
- 2.6 Installing the Radar Assembly
- 2.7 Uploading a Map Image and Configuring Georeference Settings
- 2.8 Aiming the Radar and Testing Target Detection
- 2.9 Defining Analytics Regions
- 2.10 Pairing a PTZ Camera with the Radar (Optional)
- Operation
- Configuration
- Maintenance and Troubleshooting Tips
427-0101-01-12 Revision 100 September 2020 2
This document does not contain any export-controlled information.
Radar Overview
1.1 Supplied Components
The Elara Radar kit includes these standard components:
1.2 Additional Supplies
The installer might need to supply the following items as required (specific to the installation).
• PoE power supply or PoE switch for radar power.
• Cat5e or Cat6 Ethernet cable for IP communication and PoE for system power.
• Ten-conductor accessory cable for auxiliary power.
• Radar grounding strap, radar mount, electrical hardware, connectors, and tools.
Items Included in Kit
Back box cover
10-pin connector
Ethernet port
Torx
wrench
Radar assembly
Screwdriver
RJ45 cover
Back box
to wall
bracket
mount
attached
Side cover