User's Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Moisture measurements
- 5.3 Hygrometric measurements
- 5.4 IR temperature measurements
- 5.5 Condensation measurements
- 5.6 Vapor pressure measurements
- 5.7 Selecting measurement units
- 5.8 Storing and recalling measurements
- 5.9 Alarm settings
- 5.10 Locked mode
- 5.11 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Material groups
- 8 Technical specifications
- 9 Technical support
- 10 Warranties
5 Operation
3. Use the
and buttons to adjust the high alarm threshold.
4. To disable the high alarm, simultaneously press the
and buttons.
5. When the desired high alarm threshold (or OFF) is displayed, press the
button to save the value.
The current low threshold or OFF (if the alarm is disabled) is now flashing on
the main display.
6. To switch from OFF to the numerical display, simultaneously press the
and buttons.
7. Use the
and buttons to adjust the low alarm threshold. The low
alarm value cannot exceed the high alarm value.
8. To disable the low alarm, simultaneously press the
and buttons.
9. When the desired low alarm threshold (or OFF) is displayed, press the
button to save the value and exit the alarm set mode.
5.10 Locked mode
In Locked mode, the meter ignores all button presses except
and .
The auto power off function, see section 5.1.1 Auto power off, page 11, is dis-
abled in Locked mode.
1. To enter Locked mode, press and hold the
button for 5 seconds.
The
indicator is displayed.
2. To exit Locked mode, press and hold the
button for 5 seconds once
again.
5.11 Streaming measurement data using Bluetooth
5.11.1 General
Some IR cameras from Flir Systems support Bluetooth communication and to
those cameras you can stream measurement data from the meter. The data is
then merged into the result table in the IR image.
#T559822; r.9065/9080; en-US 19