User's Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Notice to user
- 4 Customer help
- 5 Quick start guide
- 6 Camera overview
- 7 Achieving a good thermal image
- 8 Measuring temperatures
- 9 Saving and working with images
- 10 Uploading images
- 11 Working with the image gallery
- 12 Handling the camera
- 13 Camera settings
- 14 Updating the camera
- 15 Mechanical drawings
- 16 CE Declaration of conformity
- 17 About FLIR Systems
Updating the camera
14
To take advantage of our latest camera firmware, it is important that you keep your cam-
era updated.
When the camera is connected to the internet, you can check for updates and install new
firmware versions online. You can also update the camera by connecting the camera to a
computer using the USB cable.
14.1 Updating the camera online
1. Make sure the camera battery is fully charged.
2. Make sure the camera has Wi-Fi enabled and is connected to the internet.
3. To check for new firmware versions, tap
(Settings) > Device settings > Update.
4. To install a new firmware version, do the following:
4.1. Tap Download to download the installation package.
4.2. Tap Install to start the installation.
4.3. When the installation is completed, the camera will automatically restart.
14.2 Updating the camera via USB cable
Note To be able to access the camera file system from a Mac computer, you must first
install an Android File Transfer application. For more information, go to
https://www.android.com/filetransfer.
1. Make sure the camera battery is fully charged.
2. Download the FLIR update .zip file and save it in a suitable location on your computer.
3. Unzip the .zip file. You should find an update package file ending in .fuf or .run in the
zip archive.
4. Turn on the camera.
5. Connect the camera to the computer using the USB cable.
6. Open the folder Flir Camera > Images > doupdate.
7. Copy the update package file (.fuf or .run) from your computer to the folder doupdate
in the camera.
8. The update process starts automatically.
Feedback from the update process is reflected in the file update.<status>. You may
need to press F5 to refresh the folder content. Possible status values are:
• update.working: Update process is working. Leave the camera alone.
• update.error: Some error happened during update. Open file for details.
• update.done: Update is finished. You may continue working with camera.
• update.reboot: Update is finished, but you need to reboot the camera to finish the
procedure (see below).
9. If the update.reboot file appears in the doupdate folder, you need to reboot the
camera.
To reboot the camera, push and hold the On/off button
for more than 12 seconds,
until the FLIR logo appears again.
Note Do not remove the USB cable until the reboot is completed.
#T810539; r. AB/66670/66670; en-US
29