User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
2 Safety information
Note
Before operating the device, you must read, understand, and follow all in-
structions, dangers, warnings, cautions, and notes.
Note
Flir Systems reserves the right to discontinue models, parts or accessories,
and other items, or to change specifications at any time without prior notice.
Note
Remove the batteries if the device is not used for an extended period of time.
WARNING
Do not operate the device if you do not have the correct knowledge. Formal
qualifications and/or national legislation for the electrical inspections can ap-
ply. Incorrect operation of the device can cause damage, shock, injury or
death to persons.
WARNING
Do not start the measuring procedure before you have set the function switch
to the correct position. This can cause damage to the instrument and can
cause injury to persons.
WARNING
Do not change to current or resistance when you measure the voltage. This
can cause damage to the instrument and can cause injury to persons.
#T559824; r.8007/8011; en-US 2
Final before translation