User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
6 Maintenance
6.1 Cleaning and storage
Clean the meter with a damp cloth and mild detergent; do not use abrasives or
solvents.
If the meter is not to be used for an extended period, remove the batteries and
store them separately.
6.2 Battery replacement
1. To avoid electrical shock, disconnect the meter if connected to a circuit, re-
move the probe/thermocouple leads from the terminals, and set the function
switch to the
position before attempting to replace the batteries.
2. Unscrew and remove the battery compartment cover.
3. Replace the six standard AAA batteries, observing correct polarity.
4. Secure the battery compartment cover.
6.3 Fuse replacement
The fuses are accessed via the battery compartment cover.
Only use recommended fuses, see section 7 Technical specifications, page 25.
6.4 Disposal of electronic waste
As with most electronic products, this equipment must be disposed of in an envi-
ronmentally friendly way, and in accordance with existing regulations for elec-
tronic waste.
Please contact your Flir Systems representative for more details.
#T559824; r.8007/8011; en-US 24
Final before translation