User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
5 Operation
3. Press the
button to activate the displayed option:
• APO: Press the
or button to change the auto power off time.
• LIGHT: Press the
or button to change the auto backlight off time.
• RESET: Press the
button to reset the settings to the factory default.
5.11.11 Silent mode
In Silent mode, the alert beeper is disabled. Silent mode does not affect the con-
tinuity beeper.
1. Use the selector pad to select
and enable Silent mode.
5.12 Hold mode
In Hold mode, the secondary display freezes the last reading from the main dis-
play and continues to display this value. The current reading is displayed on the
main display.
1. Press the
button to enter/exit Hold mode.
In Hold mode, the
indicator is displayed.
5.13 Locked mode
In Locked mode, the meter ignores all button presses except
. The auto
power off function, see section 5.1.1 Auto power off, page 13, is disabled in
Locked mode.
1. Press and hold the
button for 3 seconds to enter/exit Locked mode.
In Locked mode, the
indicator is displayed.
5.14 Streaming measurement data using Bluetooth
5.14.1 General
Some IR cameras from Flir Systems support Bluetooth communication, and to
those cameras you can stream measurement data from the meter. The data is
then merged into the result table in the IR image.
#T559824; r.8007/8011; en-US 22
Final before translation