User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
5 Operation
5.11.9 Sampling mode
In Sampling mode, the meter logs measurement data at the user-programmed
sampling rate. The logged data can be recalled at a later time for review. Up to
20 000 records can be logged into memory. The sampling rate can be set to a
value in the range 0.5 to 600 seconds.
1. Use the selector pad to select
and enable Sampling mode.
2. Press the
or button to cycle through the mode options VIEW, RATE,
SEND, and STARTshown on the secondary display.
3. Press the
button to activate the displayed option:
• VIEW: The secondary display shows the current memory location. The
main display shows the data stored in the current memory location. Use
the
or button to change memory location. Press the button
to exit the view function.
• RATE: Press the
or button to change the sampling rate.
• START: Press the
button to start the data sampling. Press the
button to pause the sampling. Press the button to stop the
sampling.
5.11.10 Setup mode
In Setup mode, you can define the settings for various meter options:
• Auto power off: The meter enters the sleep mode after a programmable num-
ber of minutes of inactivity. The auto power off timer can be set to 10 minutes
(factory default), 20 minutes, 30 minutes, or Off.
• Auto backlight off: The display backlight automatically turns on in a dark envi-
ronment. The backlight turns off after a programmable number of minutes of
inactivity. The auto backlight off timer can be set to a value in the range of 1 to
60 minutes (the factory default is 5 minutes).
1. Use the selector pad to select
and enable Setup mode.
2. Press the
or button to cycle through the mode options APO, LIGHT,
and RESET shown on the secondary display.
#T559824; r.8007/8011; en-US 21
Final before translation