User Manual

5 Operation
• If the function switch is set to the
position, the meter attempts to deter-
mine if the device under test is a resistor, capacitor, or diode.
Auto select mode is the default mode of operation. When a new function is se-
lected with the function switch, the starting mode is Auto select and the
indi-
cator is displayed.
To enter Manual select mode, press the
button. To manually select the op-
erating mode, press the
button repeatedly.
To enter Auto select mode, press and hold the
button until the indicator
is displayed.
5.3 Auto/Manual range mode
In Auto range mode, the meter automatically selects the most appropriate meas-
urement scale. In Manual range mode, the desired range (scale) is set manually.
• To enter Manual range mode, press the
button. To change the range,
press the
button repeatedly until the desired range is displayed.
• To enter Auto range mode, press and hold the
button until the indi-
cator is displayed.
5.4 Voltage measurements
1. Set the function switch to one of the following positions:
•
for high voltage measurements.
•
for low voltage measurements.
•
for stabilized voltage measurements. The indicator is displayed.
2. Insert the black probe lead into the negative
terminal and the red probe
lead into the positive
terminal.
3. Use the
button to select AC, DC, or AC+DC voltage measurement.
• The
indicator will be displayed for AC measurements.
• The
indicator will be displayed for DC measurements.
• The
indicator will bedisplayed for AC+DC measurements.
#T559824; r.8007/8011; en-US 14
Final before translation