User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
4 Description
• Press the button to enable/disable the display backlight.
• Press and hold the button for 2 seconds to enable/disable the
work light.
Press the button to enable/disable MeterLink (Bluetooth) commu-
nication, see section 5.14 Streaming measurement data using
Bluetooth, page 22.
4.4 Display description
1. Secondary display.
2. Main display.
3. Bar graph (matches the reading on the main display).
4.5 Display icons and indicators
Indicates that the meter is measuring stabilized voltage.
Indicates that the measured voltage is greater than 40 V (AC or
DC).
Indicates that the Auto select mode is active.
Indicates that the meter is displaying maximum reading values.
Indicates that the meter is displaying minimum reading values.
Indicates that the meter is displaying the average reading.
#T559824; r.8007/8011; en-US 10
Final before translation