User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual select mode
- 5.3 Auto/Manual range mode
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Continuity test
- 5.7 Diode test
- 5.8 Capacitance measurements
- 5.9 Type K temperature measurements
- 5.10 Current measurements
- 5.11 Extended functionality
- 5.12 Hold mode
- 5.13 Locked mode
- 5.14 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Flir Global Limited Lifetime Warranty
4 Description
The meter can measure resistance, continuity, or diode polarity
through the probe inputs. The type of measurement is selected by
the
button.
The meter can measure capacitance through the probe inputs or
temperature through a thermocouple adapter. The type of meas-
urement is selected by the
button.
The meter can measure current through the probe inputs.
4.3 Function buttons
• Use the button to select Auto select or Manual select mode,
see section 5.2 Auto/Manual select mode, page 13.
• In Manual select mode, press the button to change the operat-
ing mode.
• Use the button to select Auto range or Manual range mode,
see section 5.3 Auto/Manual range mode, page 14.
• In Manual range mode, press the button to change the range
(scale).
• Press the button to toggle between Normal and Hold mode,
see section 5.12 Hold mode, page 22.
• Press and hold the button for 5 seconds to enable/disable
Locked mode, see section 5.13 Locked mode, page 22.
Use the selector pad to enable extended functionality modes and
to navigate in mode options.
Press the button to exit an extended functionality mode.
#T559824; r.8007/8011; en-US 9
Final before translation