User's Guide

427-0100-00-12 Version 110 April 2019 8
WARNING - EAR Controlled Technical Data
Installation
• Physical Security: The unit provides threat detection for physical security systems. In order to
ensure that the unit cannot be disabled or tampered with, the system should be installed with
security measures regarding physical access by trusted and untrusted parties.
• Network Security: The unit transmits over IP to secur
ity personnel for video surveillance.
Proper network security measures should be in place to assure networks remain operating and
free from malicious interference. Install the unit on the backbone of a trusted network.
• Electrostatic Discharge Safeguards:
The unit and other equipment connected to it (relay
outputs, alarm inputs, racks, carpeting, etc.) shall be properly grounded to prevent electrostatic
discharge.
1.2.5 Configure for Networking
Ethernet
Camera
connector
Guide
pins
The Saros Dome camera ball and back box are shipped in
separate boxes. The camera ball can be configured for
networking while still in its shipping box using PoE, or after
installation. If you are configuring the camera for networking
before installation, power the camera using a PoE switch or
PoE injector.
By default, a Dynamic Host Co
n
figuration Protocol (DHCP)
server on your network dynamically sets the camera’s IP
address. If there is no DHCP server on the network,
192.168.0.250 is the camera’s default IP address.
You can specify another IP address for the camera and
configu
re it for networking with the FLIR Discovery Network
Assistant (DNA) software tool or the camera’s web page.
To configure the camera for net
wor
king using the DNA tool:
Step 1 Make sure the PC and the came
ra are on the same network.
Step 2 On the PC, download the DNA s
oftware from the FLIR individual product web page at:
https://www.flir.com/browse/security/therm
al-security-cameras/
Step 3 Un-zip the downloaded file, and the
n double-click and run DNA.exe. All camera units
on the VLAN are discovered.
Click IP Setup
Online manual