User's Guide

427-0100-00-12 Version 110 April 2019 28
WARNING - EAR Controlled Technical Data
Operation
• Select the newly created region to configure the direction and detection classification specific to
this region. Once the parameters are set, scroll down and click Save.
Select
Save
Select
region
Select
direction
targets
Figure 2-4: Finishing a Region
Note
The direction (left or right) for an alarm over a tripwire line is controlled by both the properties
of each tripwire and the direction in which the line was originally drawn. A direction to the right
is to the right of a person moving from the first point to the second point of the line, etc.
• With Detection area selected, click in the video
to create the first
corner of the area. Continue adding corners (up to 16), then double-
click to complete the area. Select the newly created region to
configure the detection classification specific to this region. Once the
parameters are set up properly, scroll down and click Save.
• With Masking area selected, click in the video to create the first corner of the area. Continue
adding corners (up to 16), then double-click to complete the area.
Note
This is motion detection masking; not privacy masking. The video image will still be seen, but
alarms will not be generated. Analytics will be disabled in the masked area. The purpose is to
manually define regions that will not generate motion alarms. For example, this can be helpful to
eliminate alarms from a tree or bush moving in the wind.
Check Calibration
Step 1 Ensure camera is armed.
Step 2 Click Ye
s for
Show Rules.
Step 3 Set Show Tracking to Classified Boxe
s.
Step 4 Click Yes for
Show Trajectories.