User's Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual range
- 5.3 Current measurements
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Capacitance measurements
- 5.7 Frequency measurements
- 5.8 Type K temperature measurements
- 5.9 Continuity
- 5.10 Diode test
- 5.11 IR temperature measurements
- 5.12 MAX/MIN mode
- 5.13 Peak hold
- 5.14 Temperature units
- 5.15 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Technical support
- 9 Warranties
5 Operation
To enter Manual range mode, press the
button. To change the range,
press the
button repeatedly until the desired range is displayed.
To return to Auto range mode, press and hold the
button until the indi-
cator is displayed.
5.3 Current measurements
When measuring current using the clamp jaws, only one conductor should be en-
closed by the jaws—refer to Figure 5.1.
Figure 5.1 Correct and incorrect set-up
1. Ensure that the probe/thermocouple leads are disconnected from the meter.
2. Set the function switch to the
or position.
The
or indicator is displayed.
3. Press the trigger to open the clamp jaws. Fully enclose one conductor—refer
to Figure 5.1. For optimum results, center the conductor in the jaws.
4. Read the current value on the display.
#T559826; r.9072/9080; en-US 14