Operations Manual

Table Of Contents

Getting Started

Figure 4-6: Sensitivity menu

4.2.2 Settings menu

Select Settings menu item from the main menu and press to display the Settings menu

(Figure 4-7).



Note: This section describes general system settings, so Vapor Mode settings are omit-

ted. For a description of Vapor Mode settings, see 5.4.2 on page39.

The Settings menu contains the following options:

• Vibrate Enable: The Vibrate Enable function is a toggle, meaning you can press to

turn it ON or OFF. Vibrate Enable lets you control the vibration feature associated with

Alarm results. Turning on vibration gives you extra feedback when Alarms occur, in

addition to on screen display and audible alarms.

• Note the Vibrate Enable and Audio Enable features are independent of each

other, allowing you to choose the right kind of feedback for operational envir-

onments where audible alarms are undesirable.

• Audio Enable: This function is also a toggle. Press to turn audible alarms ON or

OFF.

• Audio Volume: Select this option to go to a configuration screen where you can

adjust the volume of audio alarms.

• Backlight: Select this option to go to a configuration screen where you can adjust

screen brightness to the desired level.

• Threat Table: The Threat Table option takes you to a glossary of substances that are

detected by the Fido X4. For examples of the kind of information that is displayed in

the threat table, see "IDcommand" on p. 46.

• Verify System: This function allows you to manually activate a verification sequence.

You can use this function at any time to confirm system performance. The verification

sequence is described in "Operating the Fido X4" on p. 30.

• Advanced Settings: These settings require a passcode to access and are covered in

the Fido X4 Administrator's Guide.