Specifications

Chapter 1: Important
information
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details, and
refer to the separate warranty document packed with
your product.
Warning: Product installation
and operation
• This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
• Raymarine recommends certified
installation by a Raymarine approved
installer. A certified installation qualifies
for enhanced product warranty benefits.
Contact your Raymarine dealer for further
details, and refer to the separate warranty
document packed with your product.
Warning: Potential ignition
source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room or
near fuel tanks).
Warning: 12 Volt dc only
This product must only be connected to a
12 volt dc power source.
Warning: Chassis grounding
Do NOT ground this product using the
chassis ground terminal.
Grounding this product to a vessel’s RF
ground may cause galvanic corrosion.
Warning: VHF Antenna
isolation
To prevent galvanic corrosion your VHF
antenna must be isolated from any vessel
metalwork using a suitable, insulated (e.g.
plastic) mounting bracket.
Warning: Positive ground
systems
Do not connect this unit to a system which
has positive grounding.
Warning: Switch off power
supply
Ensure the vessel’s power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
FCC
ComplianceStatement
ThisdevicecomplieswithPart15oftheFCCRules.
Operationissubjecttothefollowingtwoconditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
Important information
11
81381-3-en-US_A5_PRINT.pdf 11 5/4/2020 3:26:30 PM