Specifications

• Finland (fishing)
• Holland (Netherlands)
• Norway (pleasure)
• Norway (fishing)
• Sweden (pleasure)
• Sweden (fishing)
•UK
Selecting a private channel set
You can select the set of private channels you want to
use.
From the Channel set-up menu:
Menu > Set-up >
Channel set-up.
1. Select
Private channels.
The list of private channel sets is displayed:
2. Select the required private channel set.
8.6 Automatic Transmitter
Identification System (ATIS)
and Marcom-C mode
ATIS is a European system used on some inland
waterways.
VHF radios operating in an ATIS region must be
programmed with a unique ATIS number; this can be
obtained from the relevant licensing authority. The
ATIS number is attached as a digital signal at the end
of each transmission and identifies you to the relevant
authorities who monitor the system.
When operating in ATIS mode, some of the products
features are not available:
• Use of DSC functions is not permitted in ATIS regions.
• Watch modes are not permitted in ATIS regions.
• Channel scanning is not permitted in ATIS regions.
• ATIS regulations restrict the transmit power to 1 watt
for the following channels: 6, 8, 10, 11, 12, 13, 14, 71,
72, 74 and 77.
You can enable or disable ATIS using the menus (except
on Marcom-C configured units).
Marcom-C mode
Marcom-C mode is a restricted radio configuration
for VHF operators with a Marcom-C license. This is
applicable to radios operated exclusively in European
inland waterways using the ATIS system.
A Marcom-C VHF radio has the ATIS permanently
enabled. You will not be able to disable ATIS operation.
Marcom-C operation is set by the dealer at point of sale.
If you wish to enable or disable Marcom-C mode, you
must contact your Raymarine dealer.
For further information please contact Raymarine
technical support.
Enabling and disabling ATIS mode
ATIS is a European system used on some inland
waterways. A unique ATIS ID must be entered before
ATIS mode can be enabled.
With ATIS mode enabled the radio’s region will be
fixed to the INT (international) frequency band and the
following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain channels
From the Main menu.
1. Select
Set-up.
2. Select
ATIS set-up.
3. Select
ATIS.
If no ATIS ID has been set then you will be requested
to enter one before ATIS mode is enabled.
4. If an ATIS ID has already been set then select
On to
enable ATIS mode or
Off to disable ATIS mode.
8.7 AIS receiver
Depending on variant your radio may have a built-in AIS
receiver.
With the built-in AIS receiver switched on AIS information
can be sent to a connected Raymarine® MFD using
either NMEA 0183 or SeaTalkng ®.
Note: If using the built-in AIS receiver and outputting
over NMEA 0183, ensure that the baud rate is set to
0183 High speed: Menu > Set-up > Network output .
Switching AIS on and off
From the Set-up menu:
Menu > Set-up.
1. Select
AIS.
Selecting AIS will switch the internal AIS receiver On
and Off.
8.8 Set-up menu options
The Set-up menu options can be accessed from the
Main menu.
VHF operations
75
81381-3-en-US_A5_PRINT.pdf 75 5/4/2020 3:26:33 PM