Specifications

the location of the screw holes and the center hole
on the mounting panel.
To ensure that the handset’s connector points down
when connected, orientate the mounting plate so
that the lanyard grove is pointing straight up.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting
saw.
5. Pull the connector end of the cable through the hole
in the mounting surface.
6. Place the Mounting plate gasket over the end of the
connector.
7. With the recessed side facing away from the
mounting panel, place the Mounting plate over the
end of the connector.
8. Place the lanyard end of the Splash-proof dust cap
over the connector, ensuring the lanyard sits in the
recess in the Mounting plate.
9. Place the Mounting plate nut over the connector and
tighten clockwise using a 13/16 in. (21 mm) socket
wrench, being careful not to damage the plastic nut
by overtightening.
10. Secure the Mounting plate to the mounting surface
using the supplied screws.
11. Attach the Handset / Fistmic connector to the cable
connector and rotate the locking collar clockwise to
secure.
12. Connect the opposite end of the cable to the
required connector either on the Base station or
to another pass-through panel mounting plate
connector.
Note:
Drill bit, tap size and tightening torque is dependent
on the thickness and type of material the unit is to
be mounted on.
Mounting the wireless hub
Before mounting, ensure that:
• your selected location meets the location
requirements found in this document.
• you pay particular attention to the wireless location
requirements.
• sufficient space is available above or to one side of
the hub for the antenna.
• the product operates correctly at the desired location
before mounting.
1. Using the supplied mounting template, mark the
location of the fixing holes on the mounting surface.
2. Drill holes for the mounting fixings using a drill with
a suitable sized drill bit.
3. Screw the fixings approximately half way into the
holes in the mounting surface.
4. Place the Wireless hub over the fixing screws and
push down to lock into positions
5. Fully tighten the screws.
6. Connect the antenna to the top of the hub.
Antenna orientation
Radio waves are emitted from the wireless hub
perpendicular to the orientation of the hub’s antenna.
Keeping the antenna vertical should provide the best
coverage for devices on the same plane as your hub.
Positioning the antenna horizontally will provide better
coverage above and below the hub.
Installing the wireless hub antenna extension
accessory
An extension cable accessory (A80541) is available for
the wireless hub’s antenna. Using the extension the
distance of the wireless hub’s antenna can be extended
a farther 5 m (16.4 ft).
34
81381-3-en-US_A5_PRINT.pdf 34 5/4/2020 3:26:31 PM