Specifications

1 Antenna
(supplied
with the hub)
2
Nut
3 M3x10 fixing
screws x 3
4 Mounting plate
5 Mounting
surface (14
mm (0
.55
in) diameter
hole
required)
6
5 m (16.4 ft) antenna
extension cable
7
Split washer 8
Wireless hub
1. Check the selected location for the Mounting plate, a
clear flat area is required.
2. Using a pencil, offer up the Mounting plate to the
desired location and mark the location of the screw
holes and the center hole on the mounting panel.
3. Drill holes for the mounting fixings using a drill with
a suitable sized drill bit.
4. Drill the center hole using a 14 mm (0.55 in) drill/hole
cutter.
5. Pull the connector end with the exposed thread
through the center hole.
6. Place the mounting plate over the end of the
connector.
7. Place the split washer and nut over the end of the
connector and secure by hand tightening the nut.
8. Secure the mounting plate to the mounting surface
using the supplied screws.
9. Screw the antenna supplied with your hub to the
connector.
10. Connect the opposite end of the extension cable
to the antenna connector located on the top of the
wireless hub.
Mounting the charging holster for the
wireless handset
Before mounting, ensure that:
• Your selected location meets the location
requirements found in this document.
• You pay particular attention to the wireless location
requirements.
• The product operates correctly at the desired location
before mounting.
• The product does not interfere with nearby devices.
1. Using the supplied mounting template mark the
location of the mounting holes and if required, the
cable hole.
2. Drill the mounting holes using a suitable size drill bit.
3. If required, use a 6.5 mm (0.26 in) drill bit to drill a
hole for the holster’s power cable.
4. Hold the holster in place and secure using the
screws provided.
5. Place the Handset into the holster, ensuring it clicks
into position.
Installation 35
81381-3-en-US_A5_PRINT.pdf 35 5/4/2020 3:26:31 PM