Instruction manual

ManualsBrandsFlipper ManualsRemote ControlsBig Button Universal Remote

3. If your TV or STB turns OFF, the code is in that group. If the

device did not turn off, repeat until your device turns off.

4. Once your device turns off, wait until the indicator light

stops flashing, then press and release the

button to send one code at a time until your device turns ON.

5. Once the device turns ON, press TV or STB to set and try

your device. If all buttons do not work, repeat.

Note: Some devices share codes with others. As a result, it is

possible that a code matches some but not all of your device’s

functions. If this happens, repeat the process until the correct

code controls all of your device’s function.

Flipper remote can learn function signals from your existing

remote control. This allows you to copy the signals from your

current remote into the Flipper remote. Each key is

programmed separately. TV, STB, and ADD do not learn

functions.

Note: Favorite channel mode may not work with Learning set up.

1. Press and hold the TV or STB button and the

button. The indicator will flash once, then remain flashing.

Release the keys.

2. Face your existing remote control’s signal transmitter (on

the front) to the Flipper remote transmitter, with 3-5cm

gap in between the remotes.

3. Press and release the key on Flipper remote control that

you want to program from your other remote. The indicator

light will turn solid. Each key is programmed separately.

4. Press and release the same key from your existing device

remote until you see the light on the Flipper remote start

flashing again. The learning process for that key is done.

5. Keep repeating step 1-4 until you learn all the keys you

want.

6. Press the TV or STB button to set the remote.

7. Check the buttons to see if they learned the correct signal.

If not, repeat the process as needed until all buttons learn

the desired function.

Note: The remote can learn functions for any IR remote control,

including a stereo.

Channel Down

Learning Set Up:

ON/OFF

Troubleshooting

If you are experiencing difficulties with your remote control,

remember these helpful hints:

1. Make sure the remote is unlocked, by pressing TV, ADD or

STB. The light will flash once, then turn solid. Then enter

956. The light will flash twice.

2. Check to see if you are in Favorites mode or regular mode.

Press and hold DEL and dash - until the light flashes twice

and turns off. This will enter or exit favorite channel mode.

3. Press TV and make sure the remote is controlling your TV

If not, reset the remote by going to Step 1 in the

recommended set up.

4. Press STB and make sure the remote is controlling your

STB. If not, reset the remote by going to Step 2 in the

recommended set up.

5. Restore the original factory settings. Press and hold ADD

until the light flashes once then turns solid, then enter 954.

The light will be solid, then flash twice. If settings remain

in the remote, also do the same with TV and STB.

Co de Retrieval

This feature will tell you the code that is currently programmed

into the remote control. This can come in handy if you forget

the code that was entered, if you used the automatic set up

method, or for troubleshooting purposes. This instruction

works for both TV and STB.

1. Press TV. The light will flash once, then press 1, and release

both.

2. The indicator light will flash – count the flashes - this

represents the hundred digit 1xx. Note: If the light does not

flash, the digit is zero.

3. Do the same with number 2 - this represents the ten digit

placeholder – x2x.

4. Do the same with number 3 - this represents the ten digit

placeholder – xx2.