Instruction manual
3. Press and release the key on Flipper remote
control. The indicator light will turn solid.
4. Press and release the key for your Tv’s
existing remote control. The indicator light on Flipper
remote should start flashing again.
5. Press STB to save the setting.
6. Enter Dual Mode by pressing and releasing ADD. The light
will flash once.
7. Try the buttons. should control the TV only,
should control the STB, and
should control the TV. If not, repeat the process.
8. If you want to Lock, use ADD for Dual Mode in Step 5.
Note: Replacing the STB’s ON / OFF signal with the TV’s
Volume key deactivates the STB’s ON / OFF signal, so
that only the TV will turn On and Off.
Press STB. The indicator light will flash once. The
will control your STB; will control the
STB, and the should control your TV.
If does not control your TV, then follow the
instructions above under TV Only, except in #1, use the TV set
up key instead of the STB key, and follow the rest of the
instructions, including Dual Mode. This will deactivate the
TV’s ON / OFF signal, so that only the STB turns on and off,
while the will control the STB, and
should control your TV
ON/OFF
ON/OFF
ON/OFF
hi
hi
hi
hi
hi
hi
hi
hi
Volume Down
Volume
Up/Down
Volume Up/Down
Volume Up/Down
Volume Up/Down
Channel Up/Down
Channel Up/Down
Channel Up/Down
STB Only:
Ch annel En tr y Op tions
Some TV / STBs may change channels faster if an ending signal
is sent, such as OK/SELECT or ENTER.
Flipper does not send an ending signal in favorite channel
mode. If you require an ending signal, please follow the
instructions below.
Note: If you are using the favorite channel mode with a TV only,
use TV instead of STB:
hi
hi
hi
8
1. Press and hold the button and then the button
at the same time. The indicator light will flash once, then
remain flashing. Release both buttons.
2. Face your existing remote control’s signal transmitter (on
the front) to the Flipper remote control transmitter, with
3-5cm gap in between the remotes.
3. Press and release the dash - key on Flipper remote. The
indicator light should turn solid.
4. Press and release the button from your existing remote that
sends the best ending signal, usually ENTER or OK/SELECT.
The indicator light on the Flipper remote should start
flashing again.
5. Press STB to save the setting. The dash - is now your
ENTER key.
6. Test the remote to see if the ending signal is ‘learned’ by
pressing dash - and making sure it does the same function
as your existing remote. If not, repeat the process.
7. In favorite channel mode, add channels by following the
set up instructions above. Then, enter channels with the
dash - / Enter. Example: 7 dash - ADD; 23 dash - ADD, etc.
Note: STB’s generally do not require an enter signal. It is
recommended that the enter signal is not used when
entering three and four digit numbers.
STB ON/OFF
hi
hi
hi
hi
hi
hi
hi
Other Set-up Options
It is strongly recommended that you use the set up instructions
above to set up your remote control. However, there may be
instances where your device is not in the code list. If you were
not able to find the codes for your device using the
recommended process, try one of these two methods.
This method automatically sends a group of codes until your
device turns OFF. Start with either TV or STB ON.
1. Press and hold TV or STB. The light will flash once then
stay solid. Release the key.
2. Press and release the button. The remote will send
10-15 codes to your TV or STB. The indicator light flashes
quickly when sending, and turns solid when complete.
Automatic Code Searching:
hi
hi
ON/OFF
9