Instruction manual

ManualsBrandsFlipper ManualsRemote ControlsBig Button Universal Remote

top of the remote will flash once then turn solid. Release

the key.

Note: If you do not press any key more than 30 seconds, the

remote will exit the program.

3. Enter the first 3-digit code for your TV using the 0-9 key pad.

If the code is entered correctly, the light will turn off. If the

light stays on, please try again.

4. Try the remote to see if it controls the TV by pressing the

key and .

5. If the remote is adjusting your TV, go to Step 2.

6. If the remote does not adjust your TV, repeat the process

using the next 3-digit code listed for your TV brand until the

remote works.

Note: If you are unable to find a working code, see “Other Set

Up Options.”

The code for my TV is ______.

2. Press and hold the TV set-up key. The indicator light at the

ON/OFF Volume Up/Down

Step 2: Set Top Box (STB)

If you are using a TV without a STB, go to Step 3.

Flipper is preset to Motorola cable STBs. It may not work all

Motorola STBs, however. If your STB is manufactured by

Motorola, press STB once (the light will flash) and see if

Flipper works your STB. If yes, go to Step 3. If not, follow the

set up instructions in Step 1: TV, except find your STB code,

and press STB instead of TV in # 1.

The code for my STB is ______.

Step 3: Favorite Channels

Setting Favorite Channels is optional. If you do not want a

favorite channel list, go to Step 4.

You can program up to 30 of your favorite channels. When

set, only scrolls through your Favorite

Channels. The 0-9 keypad allows you to key in any available

channel. Programming favorites does not change the settings

on your STB or other remote controls.

Channel Up/Down

Note: When advancing through your favorite channels using

the buttons, please allow the

channel to switch before pressing the button again.

Make a list of your Favorite Channels. The channels will

advance in the order they are entered. For instance, if you

program channels 225, 125, 57, and then 563, the

will memorize them in that order and advance as

225, 125, 57, 563. Flipper does NOT place channels in

numeric order.

STBs and TVs generally use a three or four digit channel entry

system, 000 or 0000. To enter channels, use 0’s as a place

holder. For instance, enter channel 7 as 007 (three digit) or

0007 (four digit). For channel 22, enter as 022 or 0022. If

your TV or STB requires an Enter key to change channels,

please see “Channel Entry Options.”

Please consult your DTV manual. Use the dash “-” button, if

needed. Some DTVs do not use a dash, and instead may enter

channels in different formats, such as 401 for channel 4-1, or

0301 for channel 30-1.

If using a newer TV with an over the air digital turner, you may

need to learn the dash key from your existing remote. See

“Learning Set Up”

The instructions below assume that you are programming

Favorites to work with an STB device. If you are using a TV

without a STB, substitute the TV key for the STB key.

1. Press STB then ADD. The indicator light will flash once

then turn solid. Release both buttons.

2. Key in the first channel and press the ADD button, key in

the next channel and then ADD, and continue until all

channels are added. The light will flash one time for each

digit.

Channel Up/Down

Channel

Up/Down

Make a list:

Channel Format:

DTV channel format:

Adding Favorites: