User's Manual

User Manual - CC1W
Page 4 of 21 DOC No. 0095771
2. Mounting instructions
IMPORTANT
The employees responsible for the equipment installation and verification must take into
consideration all the actions concerning this subject specified in IEC 60079-14:2013 ed. 5.0
(Electrical installations design, selection and erection) standard. In addition to general
specifications associated with any system installed in hazardous locations, special attention
should be paid for specific requirements regarding intrinsic safety (section 12).
2.1 Base Unit
The “Base” (receiver) of the device comes with a magnet base for easy mounting on a metal
surface inside or outside of the pump controller cabinet. Base is mounting outside the hazardous
area and not intended to meet hazardous location safety standards.
Base Unit