User's Manual

User Manual - CC1W
Page 19 of 21 DOC No. 0095771
FCC Certification Statement
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This device has been designed to operate with the antenna(s) listed below, having a maximum
gain of +3.2dBi. Antennas not included in this list or having a gain greater than +3.2dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
Base Unit
FCC ID: 2AUSA-CC1WRB
Permitted Antennas
Linx ANT-2.4-CW-HW, maximum gain of +3.2dBi
Linx ANT-2.4-CW-HW-T, maximum gain of +3.2dBi
Linx ANT-2.4-CW-HWR-RPS, maximum gain of +3.2dBi
Linx ANT-2.4-CW-RCS, maximum gain of -0.2dBi
Remote Unit
FCC ID: 2AUSA-CC1WRR
Permitted Antennas
Yageo ANTX100P112B24553, maximum gain of +2.2dBi
Molex 1461870150, maximum gain of +3.0dBi