Manual

3
remier
remier
roducts
roducts
P
P
P
P
WATER TREATMENT
®
Automatic Water Conditioners
Premier Products Water Treatment | 95 North Oak St. | Kendallville, IN 46755 | 800-545-2206 | flintandwalling.com
Copyright © 2011 Flint & Walling All Rights Reserved.
Mineral Tank
Assembly
Brine Tank
Assembly
Sanitary Drain, Floor Drain or Laundry Tubs are acceptable.
Do not make a direct connection to the drain. An air gap must be present. Brine Tank Overflow drain 1/2” ID diameter minimum size (gravity flow)
Cold hard water inlet 30 p.s.i. minimum pressure 3/4” minimum pipe size
Maximum drain pipe elevation above drain port is 5 ft.
High Pressure Warning: If feedwater pressure is known to be above 125 PSI, it is strongly recommended that a pressure reducing valve be installed at this point.
Hard water to Sprinklers and any dersired unsoftened fixtures
Ground Strap
Softened Water Outlet
Manual Outlet Valve (optional)
Brine Line Tubing
110-125 Volt Continuous Power Supply Transformer
Manual Bypass Valve (Normally Closed) (optional)
Manual Inlet Valve
(optional)
Drain Port
Drain line 1/2” diameter ID minimum size Connection to sanitary sewer line (optional) Air gap device Sanitary sewer line
Drain Trap
Drain
IL1054
Typical Water Softener Installation