Specification

Installation & Operating Instructions for the

Installation ,Manual

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

3. THE FAN WOBBLES

Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly

installed, run the ceiling fan for 10 minutes to let the fan self-adjust.

If wobble occurs a er running the fan for 10 minutes, verify blade level using the following process:

LIGHT IS NOT WORKING

Check Bulb to make sure it is installed correctly

Remove non-working bulb and replace with a bulb that is known to be a good working bulb

To reset the remote control: 1) Turn oﬀ power to fan

using the wall switch or circuit breaker. 2) Remove ba eries from remote.

3) Wait 10 seconds. 4) Replace ba

and turn power on

select a point on the ceiling above the p of one of the blades. Then select the fan blade and measure from the center

of the selected blade to point on the ceiling. Rotate the fan un

e next blade is oned and repeat the

measurement using the same point from the ceiling for every blade. Measurements should be within 1/8 inch.

Customer Service

com to order a complimentary Blade Balancing Kit

Support@parrotuncle