User's Manual

FlightScope User Manual
Copyright EDH 2007-2011 E19-WA082 Issue A5_7
Page 109
10. SENSOR DAMAGE: Regularly check the sensor for signs of damage. If
enclosure is damaged it can be repaired at a FlightScope service
location.
11. REPAIRS: The sensor contains no user serviceable parts. If necessary
the sensor must be returned to your supplier for repairs. Unauthorized
opening and repair actions may invalidate warranty.
Rear Panel LED Indicators
Three color LED indicators are located on the rear
panel of the sensor.
The LED’s are:
Status
Connected
Charging
Status LED
This is a multicolor indicator that indicates equipment status as follows
Color State Description
None OFF Power is OFF or Sensor defective.
Check power connection/send for
servicing.
Blue Blinking
System
switching on
After switch on
Green
flashing (fast)
Processor
Initialization
System is powered ON and the signal
processor is running normally.
Green
flashing (slow)
Idle System is powered ON and signal
processor is running normally. System
is not armed.
Red/Green
flashing
Armed System is running and ready to
measure a shot.
Red/Off Low Battery Batteries are run down
Connected LED
This blue LED blinks when a Wireless data connection (WiFi or optional
Bluetooth) is established with the PC. The LED will be OFF when a USB cable
connection has been made with a PC.
A broken connection can often be re-established with the “Reopen
Connection” function. (Press F10 key on PC keyboard, select Sensor, select
Reopen Connection)