User's Manual

FlightScope User Manual
E19-WA082 Issue A5_7 Copyright EDH 2007-2011
Page 74
Connecting a Video Camera
FlightScope can capture a video clip of a shot from a connected video
camera. This can be used for visual feedback of the player’s motion during
the shot.
Prerequisites
In addition to the FlightScope radar, software and PC, you require:
Digital Video camera with “Firewire” (IEEE13894) or USB interface to PC
Tripod for camera
FlightScope Media Player software (supplied)
NOTE: Consult your PC and/or camera vendor to ensure that the PC and
camera have compatible interfaces and the required interface driver software
Hooking up the camera
With the FlightScope set up as usual:
Set up the camera on a tripod to one side of the tee with a good view of
the tee and of the player hitting a shot.
Connect the video camera to the PC using the “Firewire” or USB
interface port (whichever is applicable)
Switching on the Video Capture mode
Configure the FlightScope software by executing the following steps:
Press the F10 button or press the Advanced Settings button on
the main screen.
Select Sensor 

 Enable Video Capture.
This will enable the video capture mode, which will become active only after
quitting and restarting the FlightScope program.
Configuring the Video Capturing
If or when the video capture mode is enabled, configure the video capture
controls under the Advanced Settings menu (or press F10), and selecting:
Sensor 

 Video capture…