User's Manual

FlightScope User Manual

Page 25

Setup 4. Set up the sensor mode and geometry.

 Set the Detection Mode to Indoor if the system is used indoors e.g. in a

hitting cage with limited ball travel distance. Set to Outdoor mode if

hitting outdoors e.g. on a driving range or golf course.

 Choose the Units of measurement (Metric or Imperial) for the hitting

geometry.

 Enter the Sensor to Tee distance, which is from the tee/hitting spot to

the sensor face.

 Enter the Tee surface height which is the height of the tee surface

(

not the Ball Tee itself

) above the surface on which the FlightScope is

placed.

 The height of the ball tee, used with a Driver, can be specified in

addition in the Tee height for Drivers field. This value is used when

the club type is specified as “Driver”. For other clubs, this height is

assumed to be 0 (zero).

Press Next to continue.

Now, adjust the Tilt, Roll, and Ball Origin. This step will ensure that your

sensor correctly orientated and points in the right direction.

The wizard will indicate roll (sideways angle) and tilt (forward/backward

angle). Roll angle must be between +0.5 and -0.5 degrees, and tilt angle in

the range from 10-13 degrees.

Adjust the sensor feet to correct the roll and tilt angles.