User's Manual

FlightScope User Manual
Copyright EDH 2007-2011 E19-WA082 Issue A5_7
Page 17
Replace new, reconditioned NiMH cells in the cell holders, taking care that all
the cells are placed with the correct polarity orientation. With the cells
securely in place, replace the cover, and fasten the battery cover screw
(bottom).
Resetting the battery charge level monitor
If the batteries are inserted for the first time, or removed and inserted for
any reason, the battery charge level monitor circuit may not be able to
determine the charge state of the batteries accurately.
To reset the monitor, proceed as follows:
Switch the sensor on (connected to a computer but no AC adapter
connected) and let the batteries run down completely. This will be
when the sensor status indicator starts to bling “blue” or goes off
completely.
Now, connect the AC adapter, disconnect computer, and switch on
the power button to start charging. Amber Charging LED will light
up. Leave to charge for around 14 hours continuously. At the end of
charge, the amber Charging LED indicator turns off.
The system can now be used normally, and the charge level monitor will be
correctly set.