User's Manual

FlightScope User Manual
E19-WA082 Issue A5_7 Copyright EDH 2007-2011
Page 14
Switching On and Off
Switching On
NOTE
The FlightScope X2 On/Off switch is inhibited if the
handle is in the upright (carry) position, to prevent
accidental battery drain. The sensor can only be
switched on when the handle is released and partly or
all the way down.
Switch the sensor on by pushing the On/Off pushbutton on the rear panel.
A brief Push-then-Release action is needed.
When switched on, the Status LED indicator lamp will light up and blink. See
LED Indicator states below.
Switching Off - Normal
Switch the sensor off with a brief push and release of the On/Off pushbutton.
The sensor will shut down gradually starting by retracting the feet and also
performing other shutdown procedures.
The Status LED indicator will turn Blue while the shutdown is in progress,
and be off when the shutdown is completed.
Switching Off - Forced
To force rapid switch-off, push and hold the On/Off pushbutton. When the
button has been held for more than 1 second, the sensor will shut down
immediately, not retracting the feet.
Use this mode only if needed. The feet cannot be pushed in manually and
this form of shutdown will cause the feet to be extended and will not fit the
carry case.
All LED indicators will be off when completed.