User's Manual

The pole mount bracket can be strapped to a pole of at least 1½ inch diameter. The bracket is
factory configured for mounting against a vertical pole. The mounting can be changed for a horizontal
pole – see below.
Screw the clamping screws (1) and (2) partly out
(turning anticlockwise).
Place the mount (3) against the chosen pole (6) at a
suitable height from where the sensor will have a
clear view of the pitcher and batter.
Use the cambuckle straps (4) and (5) to tie the
mount to the pole. Orientate the bracket so that it is
approximately in the direction of the Pitcher’s Mound
against the pole.
Pull the straps tight enough around the pole to hold
the bracket in position against the pole.
Tighten the clamping screws (1) and (2) lightly by
turning them clockwise using the Allen key
(included).
Raise the Strike Sensor (7) and hook the slots (11)
in the Mounting Plate over the Strike Plate hooks
(12).
If needed, apply down pressure to push the sensor
unit completely down to engage slots securely on
the hooks.
Without disturbing the sensor direction, fasten the
clamping screws (1) and (2) firmly to lock the mount
securely to the pole.
Now pivot the Sensor Unit on the pole mount to
point the sensor face towards the pitcher’s mound,
using your best estimate of direction. It may be
necessary to loosen the pivot screw (8) slightly to
allow movement. When the pointing direction is
good, firmly tighten the pivot screw (8).
The mounting is now complete and the Unit can be
connected for use.