User's Manual

ManualsBrandsFlightScope ManualsElectronicsDoppler microwave sensor for baseball speed and trajectory measurement

Rhein Tech Laboratories, Inc. Client: FlightScope (Pty) Ltd

360 Herndon Parkway Model: Strike

Suite 1400 Standard: FCC 15.245

Herndon, VA 20170 FCC ID: QXP-32482

http://www.rheintech.com Report #: 2015225

Page 21 of 27

Appendix H: User Manual

Please refer to the following pages.

Summary of content (17 pages)

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix H: Client: FlightScope (Pty) Ltd Model: Strike Standard: FCC 15.245 FCC ID: QXP-32482 Report #: 2015225 User Manual Please refer to the following pages.
PAGE 2
PAGE 3
   
PAGE 4
PAGE 5
PAGE 6
            
PAGE 7
CAUTION Take precautions to prevent the sensor from being struck by a ball. For example, place the sensor behind a screen or erect a non-metallic deflector in front of the sensor for protection. Choose a position for the sensor. It must be set back between 20 and 60 ft. behind the home plate, and laterally offset within the corresponding minimum and maximum bounds illustrated in the adjacent figure. The lateral offset is needed to avoid players blocking the sensor’s view of the ball.
PAGE 8
The pole mount bracket can be strapped to a pole of at least 1½ inch diameter. The bracket is factory configured for mounting against a vertical pole. The mounting can be changed for a horizontal pole – see below. Screw the clamping screws (1) and (2) partly out (turning anticlockwise). Place the mount (3) against the chosen pole (6) at a suitable height from where the sensor will have a clear view of the pitcher and batter. Use the cambuckle straps (4) and (5) to tie the mount to the pole.
PAGE 9
Remove the pivot screw (8) and washer to free the Strike Plate (9) from the rear mount (3). 90 ͦ Rotate the rear mount (3) by 90 degrees, and attach the Strike Plate (9) again using the removed pivot screw (8) and washer in the rotated position. The mount can now be attached to a horizontal structure.
PAGE 10
FlightScope Strike can be powered from a rechargeable external 12 V DC battery, or from a mainspowered AC adapter (both included). Connect the supplied AC adapter (21) to the Strike unit (20). Connect the AC adapter to a wall socket using the supplied mains power cord (22). Switch the Strike unit on with the Power switch (23). NOTE: Make sure the battery has sufficient charge before using, so that operation can be uninterrupted.
PAGE 11
http://downloads.flightscope.com/download.php?file=/Software/FlightScopeBaseball/BaseballHost_Setup _v4.13.28.exe itunes.apple.
PAGE 12
    
PAGE 13
       
PAGE 14
None Blue blink fast Blue blink slow Blue solid Green blink fast Green blink slow Green/Red alt None Blue blinking Blue solid None Amber solid Off Starting Sleeping Error Processor starting Processor on/Idle Ready to measure Off Communications idle, not connected to a PC/device Communications active, connected to a PC/device Off Transmitter on Power supply: 12V dc @ 1A (12W) FCC Class 18 Dimensions – sensor unit: 13½ x 11½ x 5½ Inches (wide x high x deep) Dimensions – pole mount: 11 x 7½ x 5¼ Inch
PAGE 15
PAGE 16
PAGE 17