User Manual
Table Of Contents
Install
i
n
g
servos
Install the nose steering servo
1. Use a
S
ervo testor
to center the
servo.
2. Use glue to attach the servo to
the servo fixed
b
ase.
Install the nose steering servo
MG
S
m
m
m
w
w
c
I
Q
Install the main landing gear hatch door
1. Use a servo tester to center the
servo.
2. Use glue to attach the servo to
the servo fixed
b
ase.
3.
Use the two screws to secure
the servo to the servo fixed
b
ase
1.
lnstall the main gear hatch doors (B) to the
hatch door
fixed pins (A).
2.
Insert the left/right hatch door pushrods to the
same
arm hole of servo (D), and snap the
clevis
ends to the ball links of the hatch doors.
3.
Use your radio to test the closed position of
the doors. Adjust the length of the rear hatch
door pushrods to adjust the doors for the best
closed position.
4.
Repeat these steps for the main gear doors
on the second boom.
H
H
Rear hatch door push rod size
Rear
hatch door push rod installation hole position 0
�
,.
Pliqh •
Servo arm swivel lock.
A - 9g plastic servo
B - Servo fixed base
C - Screw (PWA2x8mm)