User Manual
Table Of Contents
Servo introduction
A servo or reversed servo is defined as follows:
When the servo input signal changes from 1000ųs to 2000ųs, The
servo arm rotates clockwise, its a positive servo. If it rotates
counter clockwise, its a reversed servo.
No.
2
4
N
Servo connection instruction
1.
Using the extension wires, plug the rudder and elevator
servo into receiver.
2.
Run all the other servos and LED lights, through the
extension wires and insert them into the lntegrated
circuit module
Integrated circuit module connection diagram
Use integrated circuit module
As shown in the diagram, connect the extension wires to the designated inputs.
Then connect the aileron, flap and landing gear outputs from the integrated
circuit box to the receiver .
lntergrated circuit module operation
The integrated circuit module servs two functions:
1.
It replaces the Y-wires and other connection cables, it makes the cockpit
imore neat and organized and increases the cable's connection quality.
2.
Through the integrated circuit module design, the landing gear, cabin
door, LED lights are controlled in a single box.
•Pliqht
Landing-GearO
•
•
� •
�
•
•
�
•
• •
• •
• •
• •
• •
• •
RECEIVER
-1
•
•
•
• •
P-38L LIGHTNING