User Manual

8
4-M3.0
47
2.3
5
25
4-M2.5
12.5
Ø9.0
Ø37.5
Ø9.6
3648-830KV / 3648-880KV
ESC
Item No.
KV
Value
Volate
(V)
Current
(A)
Pull
(g)
Motor
Resistance
Weight
(g)
No Load
Current
830RPM/V
14.8
41
2500
0.02
170
2.3A/10V
60A
MO136483
Propeller
880RPM/V
14.8
53
2600
0.02
165
2.3A/10V
60A
MO136484
3-Blade10×6
2-Blade12×8
18.0
24.0
11.0
8.8
12.5
3.0
11.5
53.0
∅12.0
Ø9.0
Ø6.0
4-Ø2.6
Ø20
4-Ø3.2
4-Ø3.2
43.
5
25
Motor Parameters
Unit: mm
Motor size
Motor shaft, X-fixed base
Before connecting the battery to the ESC , please
power up the transmitter and make sure the throttle
stick is in the lowest position.
Lift up on the tape to remove the Battery
compartment hatch
Battery tray
Install in the battery hatch and use the
velcro strap to secure it.
Battery Hatch Size：200×65×40mm
3S 11.1V 2600mAh ~ 3S 11.1V 4000mAh 4S
14.8V 2600mAh ~ 4S 14.8V 4000mAh
Discharge rate of C > 30C
Velcro
Battery
Landing Gear
Flap
Landing gear
Rudder
Elevator
Aileron
(power to the receiver)
Landing Gear
Rudder/Nose steering
Elevator
Aileron
Flap
Rudder/Nose steering
Elevator
Aileron
Flap
Unit: mm
TA-152H1
Item No.:FLW05
Use the markings on the control board to
correctly insert all the servo cables. Then
determine an optimum place at whch to secure
the control board down using either glue or double
sided sticky tape.
Battery Installation
The battery size range we recommend for this airplane:
Dan's Note: The control board may
not have all the outputs as shown
in the diagram. If not, plug the
existing outputs into the receiver
and route the other servos directly
to the receiver.