User Manual

6
A
B
C
D
490mm
(19- 1/4")
490mm
(19- 1/4")
2
3
1
2
3
67.8mm
(3- 1/8")
41.5mm
(1- 5/8")
2
3
1
2
3
2
3
A
PWA2x8mm
B
C
41.5mm
(1- 5/8")
2
3
A - 9g servo
B - Main wing pushrod
C - Aileron horn
D - Main wing servo trough
Servo Installation Introduction
1.Use servo tester or radio to center the
servo.
2.Use glue to install the servo and aileron
horn on the main wing.
3.Feed the servo cable through the slot, after
installing all the servos, apply the decal
over the slot.
4. Insert the end of the control rod into the
servo arm, adjust its length. And snap the
clevis to the aileron horn.
5.Repeat the above four steps for other main
wing and flap servo.
Main wing servo Installation
1.Use servo tester or radio to center the
servo.
2.Use screw A to secure the 9g servo onto
the wooden piece.
3.Slide the servo cable under the wooden
piece, and feed it through to the battery
compartment.
Elevator/rudder Servo Installation
Note: If you choose not to use the factory servo,
the chosen servo may be larger. If that is the case, you
need to remove the fixed wooden piece and glue the
servo in the servo position in the fuselage
Pushrod instructions
Pushrod diameter Ø1 .2mm
Aileron pushrod size
Flap pushrod size
Aileron pushrod mounting hole
Flap pushrod mounting hole
Rudder pushrod size
Rudder pushrod mounting hole
Elevator pushrod size
Elevator pushrod mounting hole
Pushrod diameter Ø1 .2mm
Pushrod diameter Ø1 .2mm
Pushrod diameter Ø1 .2mm
Pushrod diameter Ø1 .2mm
Steering pushrod size
Steering pushrod mounting hole
TA-152H1
Item No.:FLW05