User Manual

C
5
Antenna fixed mount
B
A
B
12
34
56
Note:
After finishing the above steps, depending on the type of control board, insert
aileron,flap servo cable and landing gear cable to the control board.
PNP Install instructions
1
2
3
4
5
6
500mm
500mm
250mm
250mm
300mm
300mm
If you need to purchase another brand servo, please refer
to the following list to choose correct size.
Positive
Positive
Reverse
Positive
Positive
Positive
Position
No.
Pos./Rev.
Cable length
Aileron(Left)
Aileron(Right)
Flap(Left )
Flap(Right)
Rudder
Elevator
Model
9g plastic
9g Digital MG
9g Digital MG
9g plastic
9g plastic
9g plastic
3. Drill two small holes and use the glue to attach the
Guns/pitot tube Assembly
Antenna Installation
Boarding Step installation
1.Insert the pitot tube A and gun B into the front of main wing.
2.Insert the antenna C to the antenna fixed mount in the
under surface of the main wing.
TA-152H1
Item No.:FLW05
Boarding Step.
A servo or reversed servo is defined as
follows:
When the servo input signal changes
from 1000ųs to 2000ųs, The servo arm
rotates clockwise, its a positive servo. If
it rotates counter clockwise, its a
reversed servo.