User Manual

4
A
B
A
B
C
D
A
B
C
D
Assembly Instructions
1. Using the Carbon Fiber rod install the
left and right Horizontal Stabilizers
2.Turn the fuselage over and use the 4
provided screws to secure the elevator.
A-Carbon tube
B-Screw
(Ø4x200mm)
(KA2.3x8mm 4pcs)
Elevator Assembly
Installing the elevator/rudder pushrods
1.Insert one side of elevator pushrod A ,through plastic tube B, to
the servo arm C.
2.Snap the clevis of elevator pushrod to the elevator horn D.
1.Insert one side of rudder pushrod A ,through plastic tube B, to the servo arm C.
2.Snap the clevis of rudder pushrod to the tail gear steering arm D.
Note: when installing the rudder pushrod, make sure the tail gear is
centered. Then attach the rudder pushrod, and adjust the plastic clevis to center
the rudder.
1.Use glue to attach the rudder horn to the rudder.(as the left
photo shown).
2.Use rudder pushrod to connect the tail gear steering arm
and rudder horn.
TA-152H1
Item No.:FLW05