User Manual

11
H1
H2
H1
H2
H1
H1H1
H2H2
Aileron
Flaps
Elevator
Rudder
Dual Rates
H1/H2 10mm/10mm
H1/H2 13mm/13mm
H1/H2 11mm/11mm
H1/H2 21mm/21mm
H1/H2 18mm/18mm
H1 28mm
H1 15mm
H1/H2 12mm/12mm
Aileron
Elevator Rudder
Flaps
Low Rate
High Rate
D/R Rate：100% D/R Rate：100% D/R Rate：100%
D/R Rate：90% D/R Rate：85% D/R Rate：85%
TA-152H1
Item No.:FLW05
Select the appropriate location and
mark them. Make sure the three
points are in the middle of the
Stabilizer
Installing Optional Plastic Hinges
Step one
Use a knife to remove
the control surface.
Step two
Mark two or three positions, apply
glue on the long end of hinges, and
insert them into the three positions.
Step three
Repeat Step Two to attach
the control surface to the
stabilizer.
The control surfaces of this airplane use a no-hinge connection design. Although proven reliable, these type of hinges
can be damaged due to errors, causing the control surface to become loose or separate. Included with this kit is a set of
plastic hinges if you wish to use them as an alternate or for repair.
According to our test results, the following rates proved to be a good starting point. Low rates are
good for initial flights or less experienced pilots. Adjust rates to suit you own style.