User Manual
Table Of Contents
Installation
A
mb
y
f
Install the elevator/rudder servos
1. Use a servo tester or radio to center the
servos
2. Use the screws (A) to attach the 9g servo to
the wooden platform
3. Slide the servo cables under the wooden
platform and up into the battery compartment.
D
A
@�
A- Tail steering arm
B - Rear gear fixed plastic part
C - Tail wheel landing strut
D-Screw (PA1.6x6mm)
Slide the Starboard elevator through the plastic piece in the tail fin until it is snug.
Slide the Port elevator over the reinforcement tube (A)and into the fuselage, ensuring that
the locking pieces on the elevator line up
T
urn the plane over and use the 4 screws (B) to secure the elevators to the fuselage.
7
Refer to the diagram at the right for assembly/
disassembly of the tail wheel landing strut.
NOTE: this piece is already assembled and
this diagram is provided is for reference.
1. Assemble the strut as shown in the
diagram
Note: If you choose not to use the
factory servo, the servo you choose
may be larger. If that's the case, you
need to remove the fixed wooden
platform and glue the servo to the servo
position in the fuselage
Elevator Assembly