frequency subwoofer www.fliaudio.co.
OWNERS MANUAL Model: FLI Frequency 10 & 12 Congratulations on purchasing your FLI Frequency subwoofer. Please read this manual in order to fully understand how to get the best results from your subwoofer and ensure that all advice on how to look after the Subwoofer is followed. Thank you for buying FLI. We hope you enjoy listening to your product as much as we enjoyed creating it. Limited Warranty All FLI goods are covered by a full twelve months warranty.
Run in procedure FLI recommends that you follow the run in procedure for the subwoofer detailed below. When your Subwoofer is used for the first time, like most brand new items it is naturally very stiff and rigid. It will take time for the moving parts of this Subwoofer to loosen up before the subwoofer will be ready to deliver its full potential.
win woofer configuration + + 2 Ohm - parallel wiring + Installation The FLI Frequency subwoofer can be installed in a variety of different ways, the most suitable will depend upon your application. Free-air installation The FLI Frequency Subwoofer can be mounted free-air, but this does not mean that the woofer can work without any form of enclosure. What it does mean is that the enclosure can be very large and therefore the subwoofer can utilise the vehicles boot as an enclosure.
Sealed enclosure installation The most basic and simple of all speaker enclosures is the sealed enclosure otherwise referred to as an acoustic suspension design. They are called acoustic suspension enclosures because the air inside the box acts like a brake to control the woofer. The sealed enclosure is the easiest design to build and tune, as long as you work within the minimum and maximum recommended volumes you cannot get it wrong.
Enclosure construction Use at least 3/4 inch MDF (medium density fibreboard) or Birch ply to construct your enclosure. It is recommend that the panels are glued, screwed and braced with sections of the same material you have used to build the enclosure from. The BlackAir woofer is capable of producing internal pressures that can literally bl ow apart badly made enclosures, so great care needs to be taken with the construction and bracing of your enclosure.
If we require a volume of 2.5cuft then we multiply this by 1728 2.5 x 1728= 4320 cubic inches. We now take 2 known enclosure dimensions that we will use, e.g height and width and divide this figure by them which will give us the depth, for example our height is 15”, our width is 20”. So our depth is 14.4” for this enclosure. Note : this formula is for the INTERNAL dimensions, please add the thickness of the material used to construct the enclosure to the formula to give you the outside dimensions.
notes
FEATURES Component subwoofer Rubber gasket adds style and provides an air tight seal for the subwoofer Electroplated IMPP woofer cone delivers fast articulate bass Butyl rubber surround delivers improved low frequency response Rubber magnet boot protects and dresses the motor Spring loaded nickel plates terminals allow heavy gauge wire to be connected directly to the voice coil Single 4ȍ voice coil FF10 Peak power RMS power Min.
Accessories can be ordered separately p from the FLI website www.fliaudi w o.com Only available in the UK If outside uk please contact your dealer or distributer from the FLI website FLI Line Level Convertor If your current head unit has no amplifierr pre outputs this FLI Line Level Convertor can n be connected directly to your rear speaker wires w to provide a stereo set of RCA connectors which w can be connected directly to an amplifier.
Accessories can be ordered separately from the FLI website www.fliaudio.com Only available in the UK If outside uk please contact your dealer or distributer from the FLI website FLI Power Capacitor The FLI powercap, a 1 farad, high specification power capacitor is another great addition to our range. This is an essential item for maximum power delivery. 10 Gauge FLI Wiring Kit For use with Car audio systems up to 1000 watts.
