Installation Guide

A. Place horizontal left wall top mitered trim (Item D) in

place, push into the corner against back wall trim piece,

then level it. Mark a level line on the wall on the top side of

the molding near the outer end. Set aside this trim piece.

B. Measure from the oor to the level mark made in 7.A

to determine the length needed for the vertical trim piece

(Item C). Cut vertical trim piece (C) to this length, but do

not cut from the pre-mitered end!

C. Fit vertical trim piece (C) over panel and plumb using a

level. If contour cutting this molding to match the shower

base shape, do so now. You can scribe the contour with a

compass, or by hand, and cut with a jig saw or utility knife.

For tub installations, the back side of the molding will not

be supported by panel material in the contour cut region

outside the tub. Use a piece of cuto scrap as a ller behind

this area of the molding. Peel away protective masking

from the trim, apply adhesive and adhere molding to panel.

Secure with masking tape as in Step 6.C.

D. Measure horizontal distance from back wall molding

piece to the tip of miter on the vertical molding. Cut the

horizontal top trim molding (Item D) to this dimension by

cutting o the end opposite the miter. Be sure not to cut

the mitered end.

E. Dry t the molding (D) in place for a tight t. Peel

away protective masking from the trim, apply adhesive

on the backside of the molding and adhere to the wall as

before. Make any minor adjustments necessary to ensure

that the mitered end makes a tight joint.

F. Repeat 7.A-7.E for the opposite wall trims (E, F).

Vertical trims installed outside shower base

Vertical trims contour cut to overlap threshold

NOTE: Vertical trim moldings are designed to be installed either:

1) resting on top of the shower base threshold, or 2) outside the

threshold and running down to the oor. Depending on the size of

your alcove opening, you may even choose to contour cut the trim

moldings to overlap the threshold partially.

7. Installation of Side Wall Trims (C,D,E,F)

– 6 –

V.2 - 3/18/2019