Installation Guide
Install Instructions
1. Installation of Inside Corner Reinforcement (J)
A. Flashing Tape Corner Reinforcements go behind the
panels in the back vertical corners for added leak protection.
This tape has been cut to length, matching the height of the
panels of your kit.
B. Apply a bead of adhesive onto both walls about 3/4 inch
away from the corner. Fold the ashing tape at the center
crease with the print side together, then press the tape into
the corner using a taping or putty type blade. Using the same
blade, atten out the tape to create a at, smooth inside
corner. Wipe away any excess adhesive.
2. Installation of Back Wall Panel (A)
A. Each wall panel should be t to the back corner, and to
the shower base. This may usually be done by trimming either
the vertical corner edge, or the edge that rests on the base. In
some circumstances you will need to trim both to achieve a
tight t. Dry t the panel by trimming with a utility knife, jigsaw,
or power plane.
B. When satised with the t, peel protective masking back
from the edges of the panel (approx. 4") and clean burs from
any rough edges. Apply adhesive in lines or dollops to the back
of the panel in a pattern every 4 to 6 inches. Use approxi-
mately one 10oz tube per 12 square feet following the adhesive
directions on the tube. Push the panel in place, lightly pound-
ing to achieve good bond.
NOTE: It is not necessary to cut the top edges of panels to be level,
as they will be covered by trim moldings. For right-hand plumbing
wall installs, reverse Panels A and B in these instructions.
3. Installation of Wet/Plumbing Wall Panel (B)
A . Hold side panel as close to plumbing wall as possible.
Scribe and trim the inside edge and bottom edge against
the shower base for best t before measuring, marking, and
cutting holes for plumbing xtures. The depth of the side
wall panels can also be trimmed down to t the opening or
your shower base, although how you decide to install verti-
cal trims C and E will inuence the width sizing of side wall
panels (see Section 4.)
– 3 –
V.2 06/2021