SDS

PerformanceProAdhesives.com Page 3 of 6
Safety Data Sheet
ADVANCED HYBRID ADHESIVE
PERFORMANCE PRO
General Information: If stored and handled in accordance with standard industrial practices no hazardous reactions are known.
Conditions To Avoid: moisture
Materials To Avoid: Reacts with: water. Reaction causes the formation of: methanol.
Hazardous Decomposition Products: Under effect of humidity, water & protic agents: methanol
Further Information: Hazardous polymerization cannot occur.
10. Stability and Reactivity
Appearance
Physical state / form: Paste
Color: White
Odor: characteristic
Safety Parameters METHOD
Melting point/melting range: not applicable
Boiling point/boiling range: not applicable
Flash point: >200˚C (>392˚F) (ISO 2592)
Ignition temperature: not determined
Lower explosion limit (LEL): not determined
Vapor pressure: not applicable
Density: 1.5 g/cm3
Water solubility/miscibility: not applicable
pH-Value: not applicable
VOC Content: 26 grams per liter
Viscosity (dynamic): 600,000 cps. at 23˚C (73˚F) (BROOKFIELD)
Explosion limits for released methanol: 5.5 - 44% (V).
9. Physical / Chemical Characteristics
Engineering Controls
Ventilation: Use with adequate ventilation. Recommended.
Local Exhaust: In case of potential decomposition products: Local exhaust ventilation which meets the requirements of ANSI Z9.2 is recommended to
control airborne containments at the point of use. (to maintain concentration below TLV).
Associate Substances With Specific Control Parameters Such As Limit Values Maximum Airborne Concentrations At The Workplace:
CAS No. Material Type mg/m
3
ppm Dust Fract.
67-56-1 Methanol OSHA PEL 260.0 200.0
67-56-1 Methanol ACGIH TWA 200.0
Re Methanol (CAS-no. 67-56-1): STEL is 250 ppm, skin notation (ACGIH); STEL is 250 ppm, skin notation (NIOSH).
Personal Protection Equipment (PPE)
Respiratory Protection: Respiratory protection is not normally required. A NIOSH approved air purifying respirator equipped with universal
multi-containment, multi –gas/vapor cartridges and at least P-99 solid/aerosol particulate filters is recommended if overexposure to dusts, mists, or
vapors could occur.
Hand Protection: Any liquid-tight rubber or vinyl rubber protective gloves.
Eye Protection: Safety glasses with side shields. Additional eye and face protection, splash-proof goggles, hood, full-faced respirator, or face shield is
recommended if splashing occur.
Other Protective Clothing Or Equipment: Additional protective clothing or equipment is not normally required. Provide eye bath and safety shower.
General Hygiene And Protection Measures: Avoid contact with eyes, skin and clothing. Avoid breathing dust/vapor/mist/gas/aerosol. Do not eat, drink
or smoke when handling. Follow standard industrial hygiene practices when using this material. Wash thoroughly after handling.
8. Exposure Controls / Personal Protection