Instructions / Assembly

– 5 –

Install Instructions



Apply enough adhesive to support the entire bottom of the

shower base. This will add additional stability and prevent

the base from shifting position.

We strongly recommend using a licensed plumber to

connect the drain assembly to the drain pipe. If your

selected drain is a glue-in style, apply the appropriate glue

to the drain pipe and the inside surface of the lower drain

body. Be sure to use the correct glue based on your drain



adhesive has been applied, place the shower base on the



Push the shower base down until the top of the nailing



Place a level on the threshold in all directions to ensure the

base is completely level. Wipe away any excess adhesive.



all stud locations. After drilling the pilot holes, apply a small

amount of silicone to the pilot holes and use 1 ½” stain-

less steel screws to secure the shower base to the studs. Be

careful not to overtighten the screws, as this can crack the





the screws. Trim all shims at the same height as the nailing



DRAIN ASSEMBLY

Pilot Holes

Strainer



Silicone Sealant





Shower Base

Lower Drain Body