Installation Instructions

FlexStoneProducts.com - 1 - 1/15
Accent Strip Trim Instructions
Please inspect packages for damage or missing pieces, and read instructions carefully prior to
installation. All FlexStone products come with a protective masking covering the image side of the
material. If you have any questions or issues, please call our customer support Monday through Friday
8:00 AM – 5:00 PM MST at 877-941-3662.
Visit FlexStoneProducts.com for up-to-date manuals, or to register your product warranty.
RECOMMENDED: Visit http://FlexStoneProducts.com/installation to access a walk-through video
and other useful installation information.
1. Accent Strip Trims can be placed at any height on the FlexStone Bath Kit surround, and are adhered
directly over the FlexStone wall panels. Accent Strips may also be used to cover a seam between
two panels, such as the case where you have purchased two kits in order to run to the ceiling.
Accent Strips are 6” high, and the kit contains 2 ea. 48” long, and 1 ea. 60” long.
2. Back Wall: Cut the back wall Accent Strip (the 60” piece) to proper length, peel away protective
masking for the Accent, apply construction adhesive to the back side of the Accent, and adhere it
directly over the FlexStone wall panel. Secure with painters’ tape while adhesive cures.
3. Left Wall: Measure from the outside
vertical trim molding to the face of the
installed back wall Accent, then cut a
48” Accent piece to this size. For the
best look, you may wish to cut a little
from the inside side of the Accent until
the pattern matches up in the corner,
then cut from the outside side to proper
length. Adhere as with back wall
Accent.
4. Right Wall: Repeat as with left wall Accent.
5. Seal top and bottom edge joints, as well as inside corners where Accent meets Accent, with 100%
silicone, as with the rest of the surround.