User guide

5113235 67
Mounting damper MC 35 PW A
Introduction
Mount the damper on the transfer unit.
Tools
Instruction
Box wrench 8 mm
Box wrench 10 mm
1 Fit the damper MC35 to the stop plate sent along
with the damping kit. Tighten the screws (2×M6).
Use the 10 mm box wrench. Do not forget the
steel washer.
2 Loosen the screws (4 or 5×M5) that hold the stop
plate that is already on the transfer unit. Use the
8 mm box wrench. Remove the stop plate.
3 Fit the stop plate with the damper and tighten the
screws (4 or 5×M5). Use the 8 mm box wrench.