User guide

50 5113235
Mounting roller kit
Introduction
Use roller kit 5049865 (65 mm) or roller kit 5050117
(45 mm).
Tools
Instruction
Box wrench 10 mm
1 Insert the slot nuts (4 x M6) in the conveyor T-
slot.
2 Mount the roller to the conveyor. Fit and tighten
the screws (4 x M6). Use the 10 mm box wrench.
The arrow shows the upper holes for fitting on XT
Compact conveyor.
The distance between the two flanges shall be:
Pallet Length (PL) + 2 mm.
3 Place the conveyors parallel to each other. Make
sure that the conveyors are on the same level
and in a horizontal position.
Fit and tighten the screws (4 x M6). Use the 10
mm box wrench.