Instruction Manual

About this manual
Created by EBCCW 00:06
3
5683EN-1
1 About this manual
1.1 Introduction
The main purpose of this manual is to help self-building end users, with little
or no prior experience, to assemble a FlexLink WL conveyor system.
Each chapter includes instructions and pictures showing how to assemble
the different parts.
1.2 Document disposition
The document is divided into the following five main parts:
• Installation site preparations
• Tools and fasteners
• Cutting FlexLink beams
• Assembly
• Start-up and testing
1.3 Installation site preparations
1.3.1 Assembly planning
Work systematically:
1 Prepare by studying your assembly drawing.
2 Ensure that the necessary tools are available.
3 Make sure you have all the materials and components needed to
assemble the conveyor system. Check with the parts list.
4 Make sure you have enough floor space to mount the conveyor
system.
5 Check to see if the floor at the installation site is even, so that all
feet can be properly attached to the floor.